a)
Lubricating hole M8 x 1 sealed with plastic cap
b)
Vent hole
c)
Mounting options
d)
Via drill hole S
e)
Via thread S1
f)
Via drill hole S
g)
Centering via collar D2
| D | 32 | mm | |
| D2 (Recommended installation: Mounting hole D2H7. ) | 42 | mm | |
| Tolerance for D3 | - 100 - 300 |
||
| E2 | 35 mm ±0.15 | ||
| H3 | 27 | mm | |
| L1 | 60 | mm | |
| N1 | 22 | mm | |
| S (Fixing screws ISO 4762-8.8) | 8.40 | ||
| V | 10 | mm |
| B | 60 | ||
| D3 | 42 | mm | |
| E1 | 45 mm ±0.15 | ||
| H | 50 | mm | |
| L | 104 | mm | |
| L1 | 60 mm | ||
| N2 | 50 | mm | |
| S1 | M10 |
| amax | 150 | m/s² | |
| m | 0.55 | kg | |
| Breakaway force | 3 | N | |
| Operating conditions | Operating conditions |
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 1.50 | N | |
| Shaft radial clearance h6 | + 43 + 11 |
||
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C |
