| D | 75 | mm | |
| A (Tolerance ISO 8062-3 - DCTG 9.) | 130 | mm | |
| B1 | 72 | mm | |
| E2 | 50 mm ±0.2 | ||
| Tolerance for H (Clamped (fastened) in relation to Ø d.) | + 13 - 21 |
||
| L | 100 | mm | |
| SW | 5 | ||
| W (Minimum size in relation to Ø d.) | 22.50 | mm |
| A | 54 | mm | |
| B (Tolerance ISO 8062-3 - DCTG 9.) | 70 | ||
| E1 | 108 mm ±0.2 | ||
| H | 50 | mm | |
| H2 (Tolerance ISO 8062-3 - DCTG 9.) | 88 | mm | |
| S | 9 | ||
| V (Tolerance ISO 8062-3 - DCTG 9.) | 14 | mm |
| Operating conditions | Operating conditions | ||
| amax | 150 | m/s² | |
| m | 2.77 | kg | |
| Breakaway force | 10 | N |
| Permissible ambient temperature (min ... max) | -10 °C ... +80 °C | ||
| vmax (Speeds of up to 5 m/s possible. Service life is limited by heightened wear to plastic parts. Tests have shown total travel from 50 • 105 m to 100 • 105 m without failure. ) | 3 | m/s | |
| FR (Frictional drags generated by Linear Bushings with integrated wiper seals on two sides when not under radial load. The frictional drags depend on speed and lubrication. ) | 4 | N | |
| Shaft radial clearance h6 | + 35 - 3 |
